Thermostats
Electric baseboards
Convectors
Fan-forced heaters
Radiant ceilings
Millivolt systems
Electric floor heating
Hydronic floor heating
Hydronic radiators / baseboards
HVAC – oil / gas / electric furnaces & A/C
Oil / gas / electric furnaces
Heat pumps
Sensors
Relays
Electric heating
Heat pump add-on
Regulators
Electric baseboards
Convectors
Fan-forced heaters
Electric floor heating
Telephone controllers
Switches
Lighting
Lighting & motors
Timers
Thermometers

 

With a built-in GFCI, this regulator is a cost-effective alternative to replacing a defective floor sensor

   

    
Print this page
 

 
MODEL & RATINGS
 

 
SPECIFICATIONS

HEATING CONTROL
Heating cycles: 15 minutes
Power setting range: 0% to 100%
E. g., power setting of "6" heats for 60%
of the 15 minute cycle - heater is on for
9 minutes and off for 6 minutes.

SWITCHING ACTION
Epoxy-soundproofed relay: Quiet operation

POWER SETTING
Manual

DIMENSIONS (H•W•P)
124 x 70 x 23 mm / 4.9 x 2.8 x 0.9 inches

 
FEATURES

Ground Fault Circuit Interrupter (GFCI) included - no need to buy separate safety cutoff

GFCI test light verifies safety cutoff is functioning properly

ON/STANDBY switch enables regulator shutdown at end of heating season for added security

Easy installation - no temperature probe required

Single control dial means easy heating control

Battery free

Low-cost option for controlling floor heating

 

 
ADDITIONAL INFORMATION

Aube floor heating regulator:
• An affordable alternative to installing a new floor sensor
• Since Aube's floor heating regulator does not use a floor sensor, a defective sensor can be left in the floor
• This avoids the time end expense of tearing up floor to replace the defective floor sensor

 


© 2013 Honeywell International Inc.
Privacy statement